Selleys Kwik Grip Water-Based Adhesive – 500ml

Selleys Kwik Grip Water-Based Adhesive – 500ml

To bond together horizontal, big, tight-fitting surfaces, use the Selleys Kwik Grip Water-Based Adhesive – 500ml. This contact-based adhesive forms a durable, heat-resistant bond with long-lasting adhesion.

The product can be used to:

• Bond timber veneers and laminated plastics, eg. Laminex and Formica to bench tops, table tops or other furniture.
• Suitable for areas where clamping or pressing facilities are either not available or difficult to use.
• Patching, replacing, and laying vinyl flooring
• Cork tiling
• Leather repairs
• Adhering flexible or other material to Aluminium
• Joining, repairing holes in tents, car covers and other outdoor equipment
• Replacing lifting edges or laying lino
• Attaching rubbers to your fridge door
• Bonding labels to tins
• Repairing your wetsuit
• Craft and scrapbooking projects (safe to use on Polystyrene)

Suitable to be used for:

• Fabric
• Laminated plastics
• Veneers
• Hardboard
• Polystyrene and Polyurethane foam
• Fibrous cement sheet
• Aluminium
• Rubber
• Cork
• Leather
• Canvas
• Felt
• Metals
• Most plastics except for polyethylene or polypropylene plastics.

How to use:

Contact Bonding

1. Make sure all surfaces are clean and dry. If you’re going to cut laminate sheets, go a little bigger. Remove the top of the tube and the foil seal with care.
2. Apply to both surfaces and equally distribute to ensure that they are completely covered. Separate the surfaces until the adhesive is practically dry (it transforms from white to clear) – about 20 minutes, but no more than 40 minutes.
3. Position items carefully, still keeping surfaces apart with dowels. When edges are perfectly aligned, remove dowels, and working from one edge, press surfaces firmly together. Grabs immediately on contact.
4. Secure the bond by rolling it across the bonded surfaces or hammering it with a cushioned block from the centre outwards. After 24 hours, the bond strength reaches its maximum. It may be necessary to clamp warped or curved surfaces.
5. Note that in cold and damp weather, drying time may be increased.

Wet Bonding – Small areas or porous surfaces

1. Ensure surfaces are clean and dry.
2. Apply to one surface, then bring surfaces together and clamp until dry.

Browse through the rest of our range of Sealants and Adhesives.